Ugin e.on sinter base, Инструкция по эксплуатации

Страница: 10 / 24

Instructions for use (rev 251121) e.ON sinter base
UGIN DENTAIRE 9
4. INSTALLATION
4.1. UNPACK
- Unpack e.ON sinter base and check that it is in perfect order (furnace and accessories).
- Any defects can be reported to the carrier.
- Remember to get the carrier to sign the delivery note.
NOTE: keep the original packaging to transport the furnace (see chapter 3.2)
4.2. INSTALLATION
- Install in a room aired. Observe the conditions indicated in chapter 3.2.
- Place the furnace on a level and aired surface. Keep a distance from other objects around not less than
25 cm. Keep it away from heat sources (radiators and/or other equipment that release heat).
- Despite excellent insulation, the furnace provides heat and, in the long term, can discolour surfaces that
are nearest.
- Do not shake the furnace, avoid vibrations and shock.
- The molybdenum silicon rods are very brittle at room temperature: DO NOT HANDLE THEM. Avoid moving
the furnace after installation.
- Dust, corrosive or explosive gases can damage the body and the insulation.
- Its forbidden placing inflammables, toxic, volatile or explosives around the furnace.
This unit requires its own power line and must be connected to a circuit breaker.
Grounding is mandatory
to avoid accidents and the dangers of overheating the power line.
Due to the power of furnace: connect it directly to the mains , do not use multiple sockets (risk of
electrical interference).
4.3. BEFORE START-UP
- Open the furnace upper cover (unscrew).
- Carefully remove the cushioning foam pad protecting heating elements.
- Then visually inspect the heating element (no damage). Avoid handling.
- Close the furnace cover (screw).