Ugin e.on sinter base, Инструкция по эксплуатации

Страница: 13 / 24

Instructions for use (rev 251121) e.ON sinter base
UGIN DENTAIRE 12
6.4. INTERFACE PROGRAM EDITOR
A total of 40 programs, composed of 40 temperature/time
pairs, can be edited and saved by selecting a different
program number, each program and pairs of can be edited.
To select a program, press the right or left arrow key: the
numbers of programs is displayed on the screen.
For each program number, the cycle parameters are
displayed as a chart:
- C represents temperature (°C), and
- T represents time (minutes).
Each program is two pages: the first page displays the pairs from C01/T01 to C20/T20 and the second page
from C21/T21 to C40/T40. The
“ NEXT PAGE ” key switches from the first page to the second page.
6.4.1. CHANGE SETTINGS
When the program number is displayed on the screen,
“press” the parameter to be modified . A numeric keypad is
displayed to select the desired value.
Enter the new value using the numeric keypad and press
“ Ok ” to save.
A confirmation message is displayed:
“ Caution: press the Ok key, the data will be saved ” .
Press “ Ok ” to confirm or “ Cancel ” to cancel.
When the desired changes of program have been made, press “ SAVE ” key to save the complete program.
After validation, the “ Working interface ” displayed on the screen.