Ugin e.on sinter base, Инструкция по эксплуатации

Страница: 18 / 24

Instructions for use (rev 251121) e.ON sinter base
UGIN DENTAIRE 17
6.7.2.
CLOSING THE CHAMBER
1 2
Check if the heating chamber is in
perfect condition: presence of dirt
or damage, any object.
- Place the sole in the chamber (both units: a & b)
- Place the tray for sinterizing (see chapter 6.7.1) at the
center of chamber (c)
3 4
Place the insulating plate (vertically)
for closing the chamber.
Close the door of the chamber.
Note: the sole can remain at its location for the realization of the following cycles.
At the end of the cycle, wear suitable gloves to remove insulating plate and tray for sinterizing: hot
surfaces - risk of burns.
6.7.3.
CLOSING THE PLATFORM AND START CYCLE
When the cycle has been selected and setting (see previous chapters) start the cycle: press “RUN” key .
Note: when start the cycle, the noise generated by the power transformer is normal.