UFO Apollo, Руководство пользователя, Страница: 9 / 28

STANDARD GANTRY SYSTEM MOUNTING
9
UFO LIGHTING
METHOD 2
-
BACK NUT FEET INSTALLATION
1. Ensure that each Gantry support leg is fitted correctly to the body in its final position and
locked into place using the grub screws before any measurements are taken.
2. Lay the Gantry on a flat surface and measure between the points shown (to half way across
each leg). Be sure to measure close to the top to ensure accuracy. If there are more than two
legs, repeat the process until all gaps have been measured and noted.
3. Use the measurement(s) to mark the centre point of each of the feet on the surface where the
Gantry will be mounted. If there are more than two legs, ensure marks are in a straight line to
avoid straining the Apollo’s structural components.
4. Drill a 6mm hole through the mounting surface, centred at each of your marks (check below
surface first to ensure there is sufficient clearance and to check that the drill bit will not damage
anything as it emerges).
5. Pass the threaded section of the foot through the hole in the mounting surface, securing it
with the nut below. Repeat for all feet. Tighten nuts, but do not overtighten..
6. Pass the wiring through the foot on one end and fit the Gantry legs to the feet, using 3x
M2x2mm grub screws (supplied) to secure each leg to its foot. Be careful not to overtighten grub
screws – only just tight is sufficient.