UFO Apollo, Руководство пользователя, Страница: 7 / 28

STANDARD GANTRY SYSTEM MOUNTING
7
UFO LIGHTING
There are 3 distinct methods of mounting the Apollo Gantry System:
method 1 - screw-down feet, method 3 - back nut, method 3 - plug & play.
STANDARD GANTRY SYSTEM MOUNTING
METHOD 1
-
SCREW DOWN FEET INSTALLATION
1. Before taking any measurements, ensure that each Gantry support leg is fitted correctly to the
body in its final position and locked into place using the grub screw(s).
2. Lay the Gantry on a flat surface and measure between the points shown below (to half way
across each leg). Be sure to measure close to the top to ensure accuracy. If there are more than
two legs (see below for further information on extra legs), repeat the process until all gaps have
been measured and noted.
3. Use the measurement(s) to mark the centre point of each of the feet on the surface where the
Gantry will be mounted. If there are more than two legs, ensure marks are in a straight line to
avoid straining the Apollo’s structural components.
4. For routing the cable, drill a 4mm hole through the mounting surface, centred at your mark, on
the end that will carry the cable (check below surface first, to ensure there is sufficient clearance
and to check that the drill bit will not damage anything as it emerges).
5. Line up the centre of each foot with your mark, then mark the position of the foot’s screw
holes. Drill pilot holes into the mounting surface, then secure the feet to the surface with suitable
screws.
6. Fit the Gantry to the feet, passing the wire through the hole you have drilled and use 3x
M2x2mm grub screws (supplied) to secure each leg to its foot. Be careful not to overtighten the
grub screws – only just tight is sufficient.