UFO Apollo, Руководство пользователя, Страница: 11 / 28

STANDARD GANTRY SYSTEM MOUNTING
11
UFO LIGHTING
METHOD 3
-
PLUG & PLAY GANTRY
Please note – Plug & Play Gantry legs are not removable from the Gantry
body, so your gantry will have all its legs fitted in their final positions on
arrival.
3. Use the measurements to mark the centre point of each of the feet on the surface where the
Plug & Play Gantry will be mounted. If there are more than two legs, ensure marks are in a
straight line to avoid straining the Apollo’s structural components.
4. Drill a 19mm hole through the mounting surface, centred at each
mark (check below surface first, to ensure there is sufficient
clearance and to check that the drill bit will not damage anything as
it emerges).
5. Insert the Plug & Play feet into their holes, ensuring the cable has
been passed through the hole first (where applicable).
6. Mark the position of the base’s screw holes. Drill pilot holes into the
surface, then secure the feet to the mounting surface with suitable
screws.
7. Place cover over base and ensure magnets engage.
8. Insert all Plug & Play legs into sockets.
1. Check that each Gantry support leg is fitted correctly to the body in its final
position and locked into place using the grub screws before any measurements
are taken.
2. Lay the Gantry down on a flat surface and measure between the points shown below (to half
way across each leg). Be sure to measure close to the top to ensure accuracy. If there are more
than two legs, repeat the process until all gaps have been measured and noted.