UFO Apollo, Руководство пользователя, Страница: 14 / 28

LINEAR WAND MOUNTING
APOLLO USER GUIDE
14
METHOD 3
-
FREESTANDING WAND
1. Drill a 4mm hole through the mounting surface for cable routing, centred at the Wand’s
selected position (check below surface first, to ensure there is suf-
ficient clearance and to check that the drill bit will not damage
anything as it emerges).
2. Line up the centre of the foot with the centre of your hole and
mark the position of the foot’s screw holes. Drill pilot holes into the
surface, then secure the foot to the surface with suitable screws.
3. Loosen grub screw in foot.
4. Insert the Standing Wand insert into the foot, ensuring that the slot
in the insert lines up with the foot’s grub screw.
5. Pass the Wand cable through the cable routing hole and insert the
Wand into the foot.
6. Rotate Wand to required position then tighten grub screw to se-
cure, but do not overtighten.
UFO will accept no responsibility for failures, nor damage caused
as a result of improper or inadequate installation, and this would also invalidate the UFO
warranty.