UFO Apollo, Руководство пользователя, Страница: 12 / 28

LINEAR WAND MOUNTING
APOLLO USER GUIDE
12
METHOD 1
-
MAGNETIC MOUNTING
This method is suitable only for applications where the mounting surface is
able to provide a strong attraction for the Wand’s magnets.
IMPORTANT
-
SAFETY INFORMATION
Ensure, when magnetically mounting Linear Wands to the chosen surface, that the surface is
flat, clean, clear of obstructions and made of a suitable, magnetically attractive metal. Carefully
test the strength of the mounting to ensure it cannot fall off, slide etc., even if bumped or
shaken.
Failure to ensure a secure mounting may cause the Linear Wand to fall, which may damage the
Wand and adjacent items. UFO will accept no responsibility for such failures, nor damage
caused as a result, and this would also invalidate the UFO warranty.
IMPORTANT
-
ADDITIONAL MAGNETIC SUPPORTS
Additional central magnetic supports are required for those unsupported spans of longer than
1147m and recommended for those longer than 900mm and (total maximum Linear Wand
length is 2995mm). If required, these will be part of your system’s design and will be supplied.
They must be firmly secured and fitted correctly as per the UFO-supplied design drawings, in
order to ensure correct and safe operation of the Apollo, and to fulfil the warranty conditions.
To fit additional central supports, remove the non-cable end support, slide the central
support(s) on to the Wand and refit the end support. Position the central supports equidistantly,
then ensure all mountings are straight & level, and secure using grub screws but do not
overtighten.
BEAM ANGLE ADJUSTMENT
Loosen the grub screw on all magnetic mountings, adjust the wand to the required angle and
tighten both grub screws, but do not overtighten. After adjustment, lie the Linear Wand, mag-
nets down, on a flat surface to ensure all magnetic mountings are aligned at the same angle.
Failure to ensure the magnetic mountings are correctly aligned can lead to the Wand magnets
not making good contact with the metal surface and could lead to the Wand falling or sliding.
IMPORTANT NOTE – 360° light beam rotation
is possible, however do NOT rotate the body
more than 180° in either direction, as this
could damage the electrical connections.
Finally, magnetically mount the Linear Wand
to a suitable metal surface, which is clean and
free of obstructions.