Non Editable
Non Editable
Editable
Non Editable
Editable
Editable
It sets the distance between the left fiber
and right fiber.
Gap
Gap set Pos.
It sets the position of the fibers to the
center of arc discharge.
Prefuse Power
It is set by the prefuse power from the
beginning of arc to the moment before the
fibers start moving forward. At this moment,
if the initial value is too low, the axis’ offset
can occur due to bad cross section angle of
the fiber. On the other hand, if the initial
value is too high, the fiber can be burned out
or shaped round, resulting in aggravating
the splice loss.
Non Editable
Editable
Prefuse Time
It is set by the prefuse time beginning of arc
to the moment before the fibers start moving
forward. The meaning of [long Prefuse time]
indicates greater [Prefuse power].
MENU
Non Editable
Editable
Overlap
It sets the duplication amount of the fiber
from the forward amount. If [prefuse power] is
weak or [prefuse time] is not long enough, the
[overlap] needs to be smaller. On the other hand,
it should be set to bigger if the arc is strong
or the time is longer.
��
