62 | SWIFT K33A ALL IN ONE FUSION SPLICER
americanilsintech.com | 63
CREATE A NEW HEATER MODE SETTING
Create a new heater mode setting when you want to customize a setting and store it for
use in addition to your default settings. Environmental or equipment deviations would
cause a user to create a new Heater Mode setting. Factors like extreme cold that effect the
heater performance is an example when a user might need to add time or temperature
to default setting. Note you must fi rst create a new setting and then Edit that setting (see
next section) to change the values as needed.
To create a new Heater Mode select Menu from the LCD display or from the K33A.
Next select “Heater” menu using the touch screen. Select New from the LCD screen and
using the arrows scroll to page that lists the type of sleeve/connector you want to create
a new setting for and select it. The Heater modes stored in memory are displayed on
the screen, select the desired Heater mode to be replaced and select “OK”. The selected
Heater mode replaces the last blank entry in the splicer menu.
NOTE:
Heater modes from 1 - 40 are system defaults. New Heater Modes start are considered
user modes and start at number 41.
EDIT A HEATER SETTING MODE
Users can Edit specifi c values like time and temperature for Heater Mode settings. It is
suggested if you change a default setting (1-40) that you change it back after you have
completed your project. If you are going to use an amended Heater Mode setting often it
is recommended that you create a new setting (see previous section) then use Edit Mode
to create a new user setting.
To Edit a Heater Mode setting select Menu from the LCD display or from the K33A.
Next select “Heater” menu using the touch screen. Select the setting you want to Edit
from the LCD screen using the arrows on the LCD display to scroll to the page that lists
the setting you want to Edit and select it on the LCD display. Next select Edit, then select
the setting you want to change then edit again to show the current setting. Enter the new
value for the setting and then select the check mark to confi rm the updated setting.
Set the new value then select the “Check Mark” icon to confi rm the change. Select the
return button to return to the Heater Mode Menu then ready to return to the ready menu.
