30 | SWIFT K33A ALL IN ONE FUSION SPLICER
americanilsintech.com | 31
POWER ON THE K33A
Press and hold for about 1.0 second without opening the windshield cover. The initial
screen is displayed as below after K33A initializes each of its on board functions. Be sure
to select the correct splice, stripper and heat mode settings to ensure accurate trouble-
free splicing results. The current splice and heat and stripper modes are displayed at the
bottom of the Home Screen. (see below)
Remove the sleeve loader from the toolbox and install into the splicer body sleeve loader
mounts as seen in the picture below:
K33A GENERAL USE & OVERVIEW
Remove the cooling tray from the toolbox and Install into the splicer body cooling tray
mount on the rear side of heater as seen in the picture below:
Insert the fi ber through the sleeve and position it from the fi ber 100mm from the fi ber end.
INSTALLING THE SLEEVE LOADER/COOLING TRAY
SETTING A SHRINK SLEEVE ONTO THE FIBER CABLE
