18 | SWIFT K33A ALL IN ONE FUSION SPLICER
americanilsintech.com | 19
The cleaning dispenser in the Swift K33A has limited capacity and should be removed for
fi lling to prevent spills onto the K33A which can cause damage or injury.
Remove the fl uid reservoir prior to fi lling to avoid overfi lling and spilling solution on
unit. Keep the K33A in a clean condition at all times as many of splicing issues are
caused by dust or moisture.
Store the K33A at room temperature for consistent performance. Store the K33A in its
toolbox to protect it during transport and handling when not in use. Never use organic
solvents such as acetone except alcohol to clean rubber part of the equipment.
To clean place a clean fi ber cleaning wipe on top of the dispenser and press down on the
alcohol dispenser pump 2 or 3 times. as shown in the picture below.
At this time be sure to completely cover the two holes on top of the dispenser to avoid
splashing the alcohol onto the K33A splicer body.
If no alcohol is discharged, remove the dispenser, open cap and refi ll the dispenser. Add
alcohol after completely removing it from the Swift K33A body by pulling upward. It is
connected to the body by magnets.
K33A CLEANING STATION
Cleaning Dispenser
Sealing Cup
Cap
Pump
Cup?
Seal?
ASSEMBLED
DISASSEMBLED
Be sure to use an approved fi ber cleaning solution as recommended by the fi ber
manufacturer.
The cleaver is designed to cleave the fi ber at a 90-degree angle. For the best results be
sure to use the following guidelines.
The coating of fi ber needs be completely removed the fi ber cleaned with fi ber cleaning
solution. The fi ber shall be properly placed in the holder or fi ber clamp upon cleaving.
The physical condition and height of the cleaver blade shall be adequately maintained.
K33A CLEAVER
Cover
Clamp
Slider
Blade
Cleaver Body
Battery?
FRONT VIEW
BOTTOM VIEW
