UC Living Rosmore Slide Control, Инструкция пользователя, Установка, Обслуживание

Страница: 16 / 32

16
LT6587 Iss 1 (10/13)
UC Living Rosmore SLIDE CONTROL Installation Instructions
SECTION NINE To Install the Appliance Continued
CHECKING GAS SOUNDNESS
After completing the gas connection to the appliance, check for gas soundness in accordance
with current codes of practice.
CONNECTING CONTROL LEVER
FUEL BED LAYOUT
Important: -
Refer to the ‘Health & Safety Notice located on page 3 of this
booklet before cleaning or replacing any refractory material.
Lay fuel bed as shown in the Users Section of these instructions.
ENSURE THE FUEL BED IS PLACED AS INDICATED IN THESE INSTRUCTIONS.
Flip the slide control lever
round so that the rubber-
capped end is protruding out
to the right as shown in the
left-hand picture. Check that it
slides freely up and down in
the nylon slide guides.
Remove the nyloc nut with a
7mm A/F spanner as shown.
Connect the link lever to the
stud at the end of the slide
control lever and replace the
nylock nut
. IMPORTANT
TURN THE NUT UNTIL IT
JUST TIGHTENS AND THEN
TURN IT BACK A HALF
TURN.
Check the operation on
the lever and mechanism
ensure that the lever springs
back to the low position when
it is released after pushing
down.