UC Living Rosmore Slide Control, Инструкция пользователя, Установка, Обслуживание

Страница: 17 / 32

17
LT6587 Iss 1 (10/13)
UC Living Rosmore SLIDE CONTROL Installation Instructions
SECTION NINE To Install the Appliance Continued
CHECKING OPERATION OF FIRE
Remove the screw from the pressure test point on the inlet elbow and fit pressure gauge. Turn
on gas to the appliance. Purge the air from the appliance by holding the control lever down to
allow the air in the pipe-work to be purged and the spark generator to ignite the pilot. Check
that the electrode is sparking at the gap between the thermocouple tip and the electrode,
continue until pilot ignition is established. Raise the control lever to its high position and allow
the appliance to run for a period of approximately 5 minutes Raise the control lever to its high
position and allow the appliance to run for a period of approximately 5 minutes. Check the inlet
pressure is 20 + 1 mbar for Natural Gas (G20) or 37+ 1mbar for Propane Gas (G31)..
CHECKING PRODUCT CLEARANCE
Check for satisfactory clearance of combustion products. Close all doors and windows and
leave fire burning for 5 minutes. Then position a smoke match just into the top of the fire
opening and move it left and right, all the smoke must be drawn into the flue. If spillage occurs,
allow a further 5 minutes. Should spillage still occur, remove appliance restrictor plate if still
fitted and repeat spillage test. If spillage still occurs turn off the fire and seek expert advice.
If an extractor fan is situated in the room this test should be repeated with the fan running. If
there is a connected room with an extractor fan, the test should be repeated with all the doors to
that room opened and the extractor fan running.
COMPLETION OF INSTALLATION
Fit the decorative trim with the four magnetic strips placed two on each vertical side flange of
the firebox - one at the top and one at the bottom. Offer the decorative trim up squarely and
centrally and push back into position. Ensure the positioning of the magnet does not interfere
with the operation of the slide control mechanism.
Position a suitable fire fret up to the front of the appliance ensuring that it meets the
specification referred to earlier.
Demonstrate the lighting and extinguishing procedures to the user and the removal and refitting
of the decorative trim and fret for cleaning.
ADVISE CUSTOMER THAT:

This appliance has a naked flame, as with all such fires it is recommended that a fireguard
should be used for the protection of children, the elderly and infirm. Fireguards should
conform to BS 6539 (1984) (Fireguards for use with solid fuel appliances).

The curing effect of heating the fuel bed and other Refractory components will cause an
initial odour. This is due to the starch used in the manufacturing process and is non-toxic.

Any debris should be cleaned from the appliance. A vacuum cleaner can be used but only
after all the loose components have been removed. The appliance should be serviced
annually by a competent person in accordance with these instructions and the appliance
checked for spillage in accordance with the method detailed in these instructions.
Hand these instructions over to the user.