UC Living Rosmore Slide Control, Инструкция пользователя, Установка, Обслуживание

Страница: 15 / 32

15
LT6587 Iss 1 (10/13)
260mmCRS.
30mm
460mm
FIX 4 OFF EYE
BOLTS IN
POSITIONS SHOWN
TENSIONING NUT
CLAMP SCREW
UC Living Rosmore SLIDE CONTROL Installation Instructions
SECTION NINE To Install the Appliance continued
GAS CONNECTION FROM THE FRONT
Connections may be made from the front of the appliance from either the left, right or centre
above the gas valve in 8-mm diameter pipe. If a left-hand connection is required the tube
should be routed below the gas control and onto the inlet elbow. The inlet elbows should be
rotated to the required position. A suitable isolating cock should always be fitted in the supply
feed to the fire to facilitate servicing.
FIXING FIRE INTO OPENING
Remove the paper backing from the length of foam seal and stick it around the rear flange of
fire. If a spacer is going to be used stick the second length (supplied with the spacer kit) around
the rear face of the spacer unit, THE FOAM SEAL MUST BE POSITIONED TO ENSURE AN
AIR TIGHT SEAL WHEN THE APPLIANCE IS FITTED.
NOTE: - DO NOT USE PERMANENT SEALING COMPOUNDS i.e. SILICONE SEALANT . THIS
COULD CAUSE THE APPLIANCE TO BE DAMAGED WHEN IT IS REMOVED FOR
SERVICING, AND COULD INVALIDATE THE WARRANTY.
If a spacer is not being used, mark position of flange hole in the fireplace front drill and fix
firebox in position with wall plugs and wood screws. If spacer is being used fix the spacer to the
fireplace first with wood screws and wall plugs then screw firebox to spacer box using screws
provided.
OPTIONAL CABLE FIXING SYSTEM
(Available on request from PARAGON
FIRES)
(for use when fixing to 18" openings or
when it is desirable not to drill the
fireplace fascia) it may
not be possible to
use the cable fixing system with some
pre-cast flues.
Drill 4 holes in the rear of the fireplace
opening in the position shown and fix
securely the 4 eye bolt provided with
suitable wall plugs
Fix the fire casing back into the opening
using the cable fixing system as shown in do
not cut off loose ends of cable after fixing,
coil and tuck carefully back
Note: when using the cable fixing kit with the
spacer, fix and seal the spacer to the rear of
the appliance flange with the screws and
foam seal provided.