UC Living Rosmore Slide Control, Инструкция пользователя, Установка, Обслуживание

Страница: 13 / 32

LT---- Iss- (--/--)
UC Living Rosmore SLIDE CONTROL Installation Instructions
SECTION EIGHT Fireplace Requirements Continued
CLEARANCE TO SIDES OF FIRE
Minimum width between vertical sides of combustible surround should not be less than 700mm
provided fire is central to surround and sides do not project more than 150 mm. When vertical
side forward projection is increased by 12.5 mm add 50 mm to inside width of surround.
N.B. When fire is fitted this provides a minimum side clearance of 100mm.
Care should be taken to prevent any damage being caused to surrounding soft furnishings or
decoration, e.g. many embossed vinyl wall coverings may become discoloured if placed too
close to the appliance.
VENTILATION
In the
United Kingdom no special ventilation bricks or vents are required into the room
containing the appliance, provided normal adventitious room ventilation exists. The installer
must satisfy this point by carrying out a mandatory spillage test.
In the
Republic of Ireland permanent ventilation must comply with the rules in force
SECTION NINE To Install the Appliance
EXAMINE FLUE / CHIMNEY
Check that the flue/chimney conforms to the required specifications as previously stated.
Examine the condition and carry out any remedial work. If the flue/chimney has been used for
solid fuel or oil, it should be swept prior to appliance installation. A smoke test must be carried
out to check that satisfactory smoke clearance has been established. If all the smoke is not
drawn into the flue, pre-heat the flue with a blowtorch or similar and re-check. If there is any
uncertainty examine for the cause and, if necessary, seek expert advice.
CONNECTING THE GAS SUPPLY
Determine where the gas supply is to be connected to the appliance. This
may be done from the front of the unit from either the left or right side, or a
concealed fitting from the rear.