UC Living Rosmore Slide Control, Инструкция пользователя, Установка, Обслуживание

Страница: 14 / 32

14
LT6587 Iss 1 (10/13)
UC Living Rosmore SLIDE CONTROL Installation Instructions
SECTION NINE To Install the Appliance Continued
PREPARING THE APPLIANCE FOR A GAS CONNECTION
If it is intended to be a concealed connection the 8mm supply should be positioned in the
opening first.
The pipe should be positioned so that when the appliance is pushed back into the opening it
enters the grommet hole at least 180mm, taking into account the requirements of BS 6891 1988
dealing with enclosed pipes.
Note: pipe-work in the opening of the fireplace to the rear of the appliance must be suitably
wrapped in accordance with the regulations
.
Ensure the spindle is pushed back inside
the control valve as far as possible. Ensure
the bell crank mechanism is swung up to
give easy access to the gas connection
point as shown.
Cut a cross slit in the rubber grommet
and feed the appliance onto the 8mm-
gas supply pipe. Position the restrictor
elbow supplied either as shown or on top
of the valve to the left of the inlet elbow
using the cutout provided.
Make the gas connection and tighten
with a spanner taking care not to apply
any force to the gas control spindle as
above. Ensure the restrictor valve is
opened fully and its cap replaced tightly.
Taking great care grip the copper protective
sleeve at the end of the gas control spindle
(DO NOT GRIP SPINDLE IN ANY OTHER
PLACE) as shown and remove the screw
from the end as shown above.
Check for gas soundness. Reconnect the
bell crank mechanism as above ensuring
that the gas control spindle is gripped only
over the protective copper sleeve and no
other part of the spindle as, ensure NO
side strain is applied to the spindle.