Ublox NINA-W1 Series, Руководство по системной интеграции

Страница: 16 / 54

NINA-W1 series - System integration manual
UBX-17005730 - R15 Software Page 16 of 54
C1 - Public
2.2 s-center evaluation software
u-blox s-center client software provides a convenient tool with which to configure u-blox standalone
modules. It runs on PCs running Windows XP onwards (x86 and x64) with Net Framework 4.5 or later
and is available for download from
www.u-blox.com . For further information about how to use this tool,
see also the s-center user guide [8].
2.3 SDK for open-CPU modules
As NINA-W10 open-CPU modules are delivered without flashed software, you develop your
application design using the utilities and device-level APIs supported by the module chipset supplier.
The ESP-IDF Software Development Kit is available from the Expressif website. It bundles the Wi-Fi
stack and the broad range of drivers and libraries necessary for building your development
environment. See also
Output power configuration .
Figure 7 shows the architecture of NINA-W10 open-CPU software in relation to the MCU, transceiver
and ESP-IDF SDK.
Figure 7: NINA-W10 open CPU software
2.4 Updating NINA-W13 and NINA-W15
New versions of NINA-W1 u-connectXpress software can be flashed to the module over the UART
interface. See also
Updating software with -center and Updating software with AT command s.
The following pins should be made available as either headers or test points to flash the module:
•
UART ( RXD , TXD , CTS , RTS )
•
Pin 27
•
RESET_N
•
SWITCH_1 and SWITCH_2 (optional)