UAZ HUNTER 315148, Руководство по эксплуатации

Страница: 49 / 136

49
Remove the oil filter 13 (see Fig. 9.3) by turning it counter-
clockwise. When installing a new filter, make sure the rubber
O-ring is in proper condition and lubricate it with engine oil,
turn the filter until the O-ring touches the plane on the engine
block and then tighten the filter another 3/4 of a turn. Make
sure no oil leak exists.
Pour the fresh oil up to the upper mark on the oil level
indicator and start the engine.
After the oil emergency low pressure alarm switches off, stop
the engine, and in 15 minutes check the oil level. If necessary,
add more oil.
ATTenTIon! The Manufacturer installed a smaller oil filter
onto the ZMZ-40905 engine, which must be replaced during the first
maintenance (when the first 2,500 km are covered) with one of the following
Fig. 9.2. ZMZ-40905 engine. Left-side elevation (the fan and the fan drive
coupling are removed for clarity): 1 — pipe of the cooling fluid supply from the
radiator to the water pump; 2 — connecting hoses; 3 — temperature control
valve housing; 4 — control system cooling fluid temperature sensor; 5 — pipe
of cooling fluid removal from the temperature control valve to the radiator;
6+ — emergency oil pressure alarm sensor; 7 — oil pressure indicator sensor;
8 — ignition coils; 9 — crankshaft position sensor connector; 10 — absolute
pressure and temperature sensor; 11 — oil level indicator; 12 — engine lift rear
bracket; 13 — exhaust manifold screen; 14 — exhaust manifold; 15 — flywheel;
16 — clutch; 17 — oil casing; 18 — clutch casing stiffener; 19 — oil drain plug