UAZ HUNTER 315148, Руководство по эксплуатации

Страница: 108 / 136

108
Perform the adjustment of headlamps in the following sequence:
1. Park the vehicle with full fuel tank, its curb weight, normal
tire pressure and loaded driver's seat of 750 N (75 kgf), on an
even level ground 5 meters away from a screen with special
markings (Fig. 9.41).
2. Place the headlamps hydrocorrector handle on the
instrument panel in a position corresponding to a one-driver
vehicle load.
3. Switch on low beams and, covering each headlamp in turn,
rotate adjusting screws so that the cutoff line from E and E' points
on the left coincides with line 1 and on the right coincides with
lines 2 and 2' for the left and right headlamps respectively. The
breaking points of the cutoff line should coincide with E and
E' points.
If it is not possible to adjust the headlamps, check the function
of the headlamp corrector.
The corrector is not repairable. In case of damage, replace
the corrector.
Adjust the front fog lights so that the area of concentrated
light on the wall or the aiming screen is located as indicated on
Fig. 9.42. To replace the fog light bulb, remove the cover of the
bulb holder by turning it counterclockwise and remove it.
front, rear headlamps, backing lamp, side repeaters of turn
signal lights, rear fog lamp. To change the bulbs, loosen screws
that fasten the lens and remove it.
license plate lamps. To change the bulbs, loosen the screw
that fastens the cap, remove the cap and the lens.
Fig. 9.40. Headlamp:
1 — Sealed beam unit; 2 — inner molding;
3 — screws; 4 — adjusting screws