UAZ HUNTER 315148, Руководство по эксплуатации

Страница: 64 / 136

64
engine lubrication system
If there is a fault in the lubrication system, the operation of
the engine must be stopped immediately.
The liquid-oil heat exchanger is provided for oil cooling in
the lubrication system.
The lubrication system is filled through the oil filler placed
on the cylinder head valve cover.
Regularly monitor the oil level in the crankcase and refill
when necessary. Check prior to the starting the engine. If the
oil level is to be checked after the engine is stopped, wait for
at least 15 minutes to let the oil drain to the crankcase. The
vehicle must rest on an even horizontal surface. The oil level
shall be between the marks "O" and "P" of oil level indicator 6
(Fig. 9.11). For frequent cross-country trips, maintain the oil
level near the "P" mark, without exceeding it.
Replace the oil filter during oil change. The used oil shall
be drained from the crankcase immediately after a drive, when
it is still hot. Prior to draining, open the oil filler cap. The oil
drains for at least 10 minutes.
When fastening the drain hole plug, check condition of the
sealing gasket. The damaged gasket shall be replaced with a new
one.
Pour the fresh oil up to the upper mark on the oil level
indicator and start the engine.
After the oil emergency pressure alarm is turned off, stop the
engine, and in 15 minutes check the oil level. If necessary, add
more oil.
Please remember, the engine alwaysPlease remember, the
engine always contains trapped oil. Pour the oil in portions,
bringing the oil level at the indicator to the upper mark "P".
The volume between the marks "O" and "P" holds about 1 liter
of oil. Oil level above the "P" mark is not allowed.
Use only the recommended oils.
Different brands of engine oils and from different manufacturers
may not be mixed.
When oil of one grade is replaced with oil of another grade,
we recommend that you to flush the engine. When a petroleum
oil is replaced with a synthetic oil and vice versa, the engine must
be flushed.
To flush the engine lubrication system:
- drain the used oil from the hot engine crankcase;