UAZ HUNTER 315148, Руководство по эксплуатации

Страница: 65 / 136

65
- pour the replacement oil or the special washing oil 2-4 mm
above the upper mark on the level indicator;
- start the engine and let it run at minimum crankshaft rpm
for at least 10 minutes;
- drain the replacement oil or the special washing oil;
- replace the oil filter;
- pour the fresh oil as indicated above.
oil filter. When replacing, install the 2101S-1012005-NK2
oil filter by KOLAN Company.
When replacing the oil filter, check the hermetic-tightness of
the heat exchanger fastening neck nut and tighten, if necessary.
When installing the filter onto the engine, make sure the
sealing gasket is in proper condition, lubricate it with oil, and
turn the filter until the gasket touches the plane on the heat
exchanger and then tighten another 3/4 of a turn. Make sure
there is no oil leak in the sealed joints.
Fig. 9.11. ZMZ-51432 engine (left-side view):
1 — turbocharger; 2 — control system cooling fluid temperature sensor;
3 — temperature control valve housing; 4 — oil filler cap; 5+ — oil inciden-
tal pressure sensor; 6 — oil level indicator; 7 — cooler of recirculating gases;
8 — exhaust gases recirculation valve; 9 — flywheel; 10 — clutch; 11 — oil
casing; 12 — oil drain plug