UAZ 2001 ???-2206, Инструкция по эксплуатации

Страница: 58 / 112

58
When installing the springs, carry out the last tightening of
the U-bolt nut on the automobile standing on the wheels.
Maintenance of the shock absorbers consists in periodically
checking them for tightness and reliable fastening, as well as in
changing the fluid in compliance with the instructions laid down
in Lubrication Table.
If leakage of fluid through the rod seal and the reservoir
sealing rings is detected, tighten nut 18 (Fig. 49). If the leakage
fails to be eliminated, repair the shock absorber in a workshop.
Change fluid in the shock absorbers every 100 000 km of run.
Wheels, Tyres
The spare wheel attachment is shown in Fig. 50.
The spare wheel should be secured properly on the carrier by
means of the sector 2 (FIg. 50, A) or bracket 7 (Fig. 50, Á).
To avoid burns of the tyre by the exhaust pipe before securing
the spare wheel, move the spare wheel from the exhaust pipe
until a clearance of not less 40 mm is reached.
When maintaining, inspect the wheels and tyres for proper
condition, check the wheel attachment nuts for tightening and
the tyre inflation pressure.
To provide for uniform tightening of the nuts, tighten them
alternately, every second one.
Before every run, check the condition of tyres and eliminate
detected defects. Periodically check the tyre inflation pressure
and bring it to normal, if required.
Check inflation pressure in cold tyres.
If an uneven wear of the front wheel tyres is detected, check
and adjust the toe-in of the front wheels.
With the normal tyre inflation pressure the toe-in of the front
wheels should be such that the dimension "A" (Fig. 51) measured
by the center line of side surface of the tyres ahead of the axle
is 1.5-3.0 mm less than the dimension "B" measured back of the
axle. As required, adjust the toe-in of the front wheels by
changing the length of the steering tie rod; then, having loosened
locknuts 1 and 3 provided with the right- and left-hand thread,
rotate adjusting sleeve 2 (Fig. 52) to set a required value of the
toe-in. Upon adjustment, tighten the locknuts. To provide
uniform wear of tyres, carry out tyre rotation as a preventive
treatment.