UAZ 2001 ???-2206, Инструкция по эксплуатации

Страница: 35 / 112

35
- remove the vacuum governor hose;
- remove the rocker cover;
- using mark (Fig. 20) on the crankshaft pulley, set the piston
of No.1 cylinder at the TDC on the compression stroke and
check the clearance between the rockers and valves of No.1, 2,
4, 6 with the feeler gauge. In the case of an incorrect clearance,
screw out locknut (Fig. 21) of adjusting screw and rotating the
letter with a screwdriver, set a required clearance by means of
the feeler gauge. Then, holding the adjusting screw with the
Fig. 16. Engine
(l.h. view):
1 -fine fuel filter; 2 -oil
filler cap ; 3 - oil dip-
stick; 4 -rocker arm
cover; 5 -cylinder head;
6 -ignition-distributor;
7 -starter; 8 -clutch
housing; 9 -clutch hous-
ing (lower part); 10 -
fuel pump; 11 -engine
mounting bracket
Fig. 17. Engine
(r.h. view):
1 -cylinder block drain
cock; 2 -cylinder block;
3 -inlet manifold; 4 -
inlet manifold damper;
5 -inlet manifold; 6 -
carburettor; 7 -alterna-
tor; 8 -oil pressure trans-
mitter; 9 -low oil pres-
sure warning lamp trans-
mitter; 10 -oil filter;
11 -oil sump drain plug