UAZ 2001 ???-2206, Инструкция по эксплуатации

Страница: 54 / 112

54
Maintenance of the Propeller Shafts
Periodically check tightening of the bolts attaching the
propeller shaft flanges, periodically lubricate them, clean the
propeller shafts of dirt.
Lubricate the splined joint through the grease fitting 1
(Fig. 44) screwed in the slip yoke, and the needle bearings are
lubricated through the grease fittings 2 on the centre cross.
Lubricate the needle bearings until grease is shows up from
under the working edges of the centre cross seals.
Apply grease according to the directions of Lubrication
Table.
Do not apply too much grease to the splined joint as it would
bleed through the splined joint and that would provoke the
preliminarly failure of the seals and could force the plug of the
slip yoke.
Use a special tip to be fitted on the grease gun to lubricate
the propeller shaft. The tip is available in the driver’s tool kit.
Fig. 44. Rear propeller shaft:
1 -grease fitting for lubricating of splined joints; 2 -grease fitting for lubricating
of joint needle bearings
Maintenance of the Rear Axle
Maintenance of the rear axle comes to maintaining the level
of oil in the housing and its timely changing, checking the
condition of the seals. Periodically clean the safety valve 1
(Fig. 45), tighten up all fastening parts.
Apply grease according to the directions of Lubrication
Table.
Check the oil level which should reach the edge of the filler
hole.
Drain oil through the hole at the bottom of the housing by
screwing out the filler plug.
Check also the level and change oil in the hub drive housings
when the axles are provided with the hub drives.