UAZ 2001 ???-2206, Инструкция по эксплуатации

Страница: 55 / 112

55
Fig. 45. Rear axle:
1 -safety valve; 2 -filler hole plug;
3 -drain hole plug
Maintenance of the Front Axle
All the directions on maintenance of the rear axle are valid
for the front axle.
Maintenance of the steering knuckles should be carried out
additionally.
Lubricate the steering knuckle kingpins through the grease
fitting 10 (Fig. 46) according to directions of Lubrication Table.
When inspecting the steering knuckles of the front axle, check
to be sure that the adjusting bolts 27, the steering stop 28 are in
serviceable condition and are reliably locked with the nut.
The front driving axle is provided with a device for
disengagement of the front wheels (Fig. 46 III).
For disengaging the front wheels, remove hub cap 21 and by
screwing out the bolt 19 set coupling 18 in position in which a
circular indicating groove "a" on the surface of coupling is
arranged in one plane with the face of flange
17 (Fig. 46, view III). Having set coupling 18 in a required
position, screw on hub cap 21.
For engaging the wheels, screw in bolt 19 as far as it will go.
Be sure to engage and disengage both front wheels.
Some automobiles could be equipped with a sleeve for
disengagement of the front wheels, shown in Fig. 46 IV. For
disengaging the wheels, turn the disk of the sleeve counterclock-
wise as far as it will go arranging in one plane the mark "á" with
the figures "4õ2". For engaging the wheels, turn the disk of the
sleeve clockwise as far as it will go arranging in one plane the
mark with the figures "4õ4".
Never engage the front axle when the front wheels are
disengaged.