APT-5 - User’s Manual (EU) Rev. 2020-01 en
13
SECTION B – USER INFORMATION
07
INSTALLATION FOR USE – ARMS EXERCISE
Position the
APT-5
on a level table top close to an electrical socket outlet (Figure
5). For the
APT-5
Hi-Lo: loosen the height securing knob (Figure 1A-8), pull the grey
ring of the height release knob (Figure 1A-7) and adjust the unit to the required
height. Release the grey ring and tighten the height securing knob (Figure 1A-7).
Loosen the angle-securing knob (Figure 5-1) and adjust the
APT-5
to the required
angle. To increase the angle, lift the body of the
APT-5
, allow it to “click” into
one of the operating positions and retighten the securing knob. To decrease the
angle, pull the an gle release knob (Figure 6), lower the body of the
APT-5
, allow it
to “click” into another operating position and tighten the securing knob.
CAUTION:
Make sure that the minimum distance between crank arm and the
table surface is approximately 5 cm. / 2” (Figure 5-2).
Connect the output connector (Figure 7-1) of the power supply (Figure 7-4) to
the
APT-5
power input socket (Figure 7-2a) while ensuring correct position of
connector groove opposite the guide key of socket (Figure 7-2b).
NOTE:
The
APT-5
must be used only with an original APT-5 Power Supply unit.
Step 1:
Step 2:
Step 3:
Содержание APT-5
Страница 1: ......
