25
4
Create Pattern Through Control Panel
User can create new pattern directly through the control panel.It is useful when the user can
not get a computer to create a pattern. The operation steps to do this job is described below by 2
examples.
Example 1:
We need to create a pattern which drawing is as follows.
.
There are 3 stitches in this pattern. Assume that the coordinate of the 3 stitches is: (-4,2.5),
(4,2.5),(-4,2.5). It must be pointed out that the x coordinate(for width) is absolute value but the y
coordinate(for feed pitch) is relative value to the previous stitch. We note that the y coordinates of
the 3 stitch equal to each other.We name this type of pattern as “constant feed” pattern. To input
the stitches of constant feed pattern, for efficiency, we only need input the x coordinate. The y
coordinate should be set through the
Normal Feed Pitch Display
before enter into the pattern
create mode.
The following is the operation steps to create this pattern.
(1) Press the N1+ and N4+ key simultaneously to let the main display show
“Prog”.
(2) Press N1- key, the main display will show the number of the first unused pattern, e.g.
Normal Feed Pitch Display
The data should be set to 2.5
in this case
Adjust button
N1+
N4+
