Tycon Power Systems EZ-Go +, Руководство пользователя

Страница: 6 / 16

6
isting EZ - Bridge
®
unit more easily. Once you feel comfortable with the
system and its operation, we would recommend the following security
changes :
a. PASSWORD: Change the password on all units by going to
SYSTEM | ADMINISTRATION and re - setting the radio pass-
word. The default password = link4me . The user name, EZ-
TEAM, cannot be changed .
b. ENCRYPTION: Change the WPA2 encryption key by going
to NETWORK | WIFI | EDIT | INTERFACE CONFIGURATION
WIRELESS SECURITY | KEY .
TECH TIP: When setting encryption you must setup all units to
have identical encryption keys. You can setup the remote units first
and then the local unit last in order to be able to configure all units from
one location across the wireless link. Keys can use any ASCII charac-
ters. The more random the key, the more secure the code.
5. TRANSMIT POWER (Tx Power): Normally there wouldn ’ t be any
reason to change the power setting. The factory default setting is MAX.
which should be good for most applications. If you have a very short
link you will actually get better performance if you turn down the Tx
Power. This is because at close range there is too much power and it
has a tendency to overload the input stage of the units and perfor-
mance degrades. The best performance will be seen with signal
strength of – 40 to – 60 dBm. This signal strength can be viewed on the
STATUS | OVERVIEW page. To change the Tx power go to NET-
WORK | WIFI | EDIT | TRANSMIT POWER.
NOTE: We recommend if changing power, start by cutting it in half,
check signal levels and then adjust to fall within the – 40 dBm to – 60 dBm
range.
TECH TIP: You may want to play around with different settings to
see what works best for your particular link.
6. SITE SURVEY: The site survey is a very useful tool to determine
what wireless devices are within range of your EZ - Go
®
and could be a
source of interference that could cause degraded performance. Go to
NETWORK | WIFI and then click on SCAN or SPECTRUM. The list will
show information on all wireless devices within the range of the EZ -
Go
®
. It will also allow you to connect the client to an existing AP.
7. FACTORY DEFAULTS : If at any time the system stops working be-
cause of changes made to the settings, you can get back to the original
settings by resetting to factory defaults. Go to SYSTEM | BACKUP/
FLASH FIRMWARE | PERFORM RESET. Any customized settings will
be lost once this process is initiated.