Tyco 3G4000W, Руководство по установке

Страница: 9 / 28

Status LEDs
Operating Modes
The 3G4000W features two distinct operating modes: Normal Mode and Service Mode. The unit will be in Normal Mode when both
the cover and wall tamper are in a restored state. If either a cover tamper or wall tamper are present, the unit will be in Service
Mode.
Normal Mode
The 3G4000W interface has four status LEDs. The following describes the status LEDs when the communicator is in normal
operating mode (cover and wall tamper both in the restored state).
NOTE: The top two LEDs blink during the Initializing and Programming phases.
Red - This LED indicates trouble conditions.
1 Flash: Wireless Network Trouble
2 Flashes: Battery Trouble
3 Flashes: Input Power Trouble
Solid: Other Troubles (use Service Mode to view)
Blue - This LED indicates cellular radio activity. When this LED is on (solid), a phone line trouble condition exists. This LED turns on
when the interface switches to the wireless network (due to a landline trouble condition). This LED will also flash once when the
3G4000W transmits a signal and twice when the 3G4000W receives a kiss-off from the central station.
NOTE: If the 3G4000W is programmed to be the primary communicator, the blue LED will remain off but will still flash during the
signal transmission as described above.
Green/Yellow (Top) - This LED indicates signal strength and network technology. If the 3G4000W is operating in over a 2G
channel, the LED will be YELLOW. If the 3G4000W is operating over a 3G channel, the LED will be GREEN. When this LED is On,
the reception is optimal. This LED switches On only when the bottom LED is on.
Green/Yellow (Bottom) - This LED indicates signal strength and network technology. If the 3G4000W is operating in over a 2G
channel, the LED will be YELLOW. If the 3G4000W is operating over a 3G channel, the LED will be GREEN. If this LED is Off and
the Red LED is On, the Wireless Network service is unavailable (NO SERVICE). This LED flashes when the Wireless Network
reception is poor. If this LED is on, the 3G4000W is able to communicate with the 3G (HSPA) or 2G (GPRS) network.
Service Mode
To view detailed trouble information on the status LEDs, the 3G4000W must be placed in Service Mode by causing a cover or wall
tamper condition. When in Service Mode, the status LEDs will indicate the trouble condition as follows.
Flashes
Trouble Conditions
Red LED Blue LED
1 Off Wireless Network Trouble
2
Off Battery Trouble
3 Off Input Power Trouble
1 Flashing Insufficient Signal Strength – registered on cell network
1 On Radio / SIM trouble – Radio or SIM unresponsive
2 On Receiver Not Available
3 On Supervision Trouble
4
On Wall / Cover Tamper Trouble
Off - No trouble conditions present