409-10016
ELT Machine 1338600-[
Rev H
4 of 34
Tyco Electronics Corporation
Capacity: 13,345 Newtons [3,000 lb] Maximum Crimp Force
Deflection: 0.13 mm [.0046 in.] Maximum per 4,448 Newtons [1,000 lb] Crimp Force
Noise: Less than 76 dBa Typical at operator position with standard mechanical feed applicator
Weight: 68.86 Kilograms [143 lb]
Height: 510 mm [20 in.] without reel supports
Electrical: 100-240 Vac, 50/60 Hz, Single-Phase Current
Air: 620-760 kPa [90-100 psi], 2.83 liters/sec (6 scfm) When required for use with air-feed applicators
Figure 2
Physical Environment: Temperature: 4.4
°
-40
°
C [40
°
-104
°
F]
Altitude: Not Applicable
Relative Humidity: Less than 95% (non-condensing)
Transportation and Storage: Store in a clean, dry environment after coating all surfaces lightly with
a rust preventing oil.
When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.
Denotes an imminent hazard which may result in moderate or severe injury.
Denotesa condition which may result in product or equipment damage.
Highlightsspecial or important information.
Reasons for reissue are in Section 9, REVISION SUMMARY.
2. DESCRIPTION
The ELT machine was designed to be used as a stand–alone semi–automatic bench unit. It is assembled with
metric hardware.
Measurements are in metric units [followed by U.S. customary units in brackets]. Some commercial items may
contain non-metric hardware.
The ELT machine accepts a wide variety of miniature (mini) quick–change applicators, with minor adjustments,
thus providing a great selection of terminals for many applications. Figure 3 lists changeover cams required to
run 1
1
/
8
–in. stroke cams (for AMP–O–LECTRIC Model “K” terminating machines) and 1
5
/
8
–in. stroke cams (for
Model “T” and Model “G” terminating machines) in the ELT machine.
Some heavy-duty mini applicatorsrequire special camsthat are not listed in Figure 3. Refer to the applicator logs
shipped with the applicators for additional information.
DANGER
CAUTION
!
NOTE
i
NOTE
i
NOTE
i
