TWR Lighting E-2/3DB, Руководство пользователя

Страница: 14 / 49

E-2/3DB CONTROLLER
E:\Documents and Settings\Administrator\Local Settings\Temporary Internet Files\OLK3\E2-3DB.doc
Rev. 01/13/00; Rev. 07/2000 o2L/H
Rev. 10/2000 (dwgs. 100239, 601, 601-01, 601-02, H02-258, 100031, 279L, 274S, 100089)
Rev. 06/21/00 (Reformatted Text; Revised Pg. 3 (2.4.1, 20 amp to 30 amp)
Pg. 10
2.7.2 Red Strobe Failure (RF)
Red strobe failure testing can be performed in the night mode
operation. Check for status of strobe beacons. Turn "on" switch
SW2 on controller panel and status should change after an eight (8)
second delay. This testing will cause the unit to go into the back-up
white strobe operation. To clear this situation, turn off SW2 and reset
the breaker.
2.7.3 Power Failure (PF)
While the controller is in normal operation, shut off power to the
controller at the breaker panel. Alarm should be prompt. Reset the
breaker to resume normal operation.
2.7.4 Photocell (PC)
Controller should be in the daymode of operation when performing
this test. Check status of operation. Turn SW1 on (or) cover the
photocell and operation status should change state. After test, turn
SW1 to normal operating position.
2.7.5 Sidelight #1 Alarm (SA1)
Controller should be in the nightmode of operation. Check status of
operation. Pull fuse switch SL1 open. Alarm should occur within five
(5) seconds. After test, re-engage fuse switch SL1.
2.7.6 Sidelight #2 Alarm (SA2)
Controller should be in the nightmode of operation. Check status of
operation. Pull fuse switch SL2 open. Alarm should occur within five
(5) seconds. After test, re-engage fuse switch SL2.
2.8 CONTROLLER CONFIGURATION
(Refer to Drawing H01-279)
This unit is factory setup to be a master controller. If this unit is to be used
in conjunction with an additional unit, change dip switch settings as drawing
indicates. The following connections will need to be interfaced between
systems.