Twin Eagles Service (562) 263-3600 | 8
LP GAS HOOK-UP
Install the factory-supplied hose and regulator assembly as shown. Connect the 3/8” flare end of the
hose to the grill coupling using a ¾” open wrench. Do not apply pipe sealant to the 3/8” flare connection. Con
-
nect the regulator to the LP cylinder hand tighten it, do not use a wrench. Check for leaks using a soapy water
solution. (Reference page 11 for leak test procedure).
Important Note:
An enclosure for LP gas cylinder must be vented on the level of the cylinder valve and at floor level. The
effectiveness of the opening(s) for purposes of ventilation shall be determined with the LP gas supply cylinder in
place. This shall be accomplished by one of the following:
• One side of the enclosure shall be fully open; or
• For a cylinder enclosure having four sides, a top and a bottom, and intended for installation in a built-in
enclosure:
1. At least one ventilation opening shall be provided on the exposed exterior side of the enclosure lo
-
cated within 5 in (1.27mm) of the top of the enclosure and unobstructed. The opening(s) shall have
a total free area of not less than 1 in²/lb (14.2 cm²/kg) of stored fuel capacity.
2. At least one ventilation opening shall be provided on the exposed, exterior side of the enclosure 1 in.
(25.4 mm) or less from the floor level and shall have a total free area of not less than ½ in²/lb (7.1
cm²/kg) of stored fuel capacity. The upper edge shall be no more than 5 in (127 mm) above the floor
level.
3. Every opening shall have a minimum dimension so as to permit the entrance of 1/8 in (3.2 mm) rod.
CAUTION:
PROVIDE ADEQUATE VENTILATION HOLES IN THE ENCLOSURE FOR
SAFETY PURPOSES IN THE EVENT OF A GAS LEAK.
4.50” MIN CLEARANCE TO
ALLOW LID TO FULLY OPEN
20LB (5 GALLON) LP
CYLINDER
DO NOT PLACE MORE
THAN ONE CYLINDER
IN THE ENCLOSURE AT
ANY TIME.
VENTS REQUIRED ON
ENCLOSURES FOR LP
CYLINDERS
(MUST BE IN ACCORDANCE
WITH ANSI Z21.58
STANDARDS)
BRASS COUPLING
3/8 FLARE BOTH ENDS
OF THE REGULATOR
INSULATING JACKET
HI-PRESSURE LP
HOSE ASSEMBLY
LP REGULATOR
TYPE 1