1
GETTING STARTED
Safe and satisfactory operation of the Breakfast Club depends upon its proper installation. The installation,
adjustments and service of the Breakfast Club must be performed only by a qualified installer and service
technician.
Proper location and proper use is essential to insure safe and continued trouble-free operation. Any alterations
made to the appliance will void the product’s warranty.
Before installing, check the rating/serial plate of the Breakfast Club. Use only the electrical power supply and
type of gas supply (natural or propane) as specified on the rating/serial plate. This information is found on the
serial plate, located on the inside wall of the left hand side panel.
Electrical Specification
The appliance should only be taken apart be a qualified technician, or electrical shock may occur. It is rated
at 120V, 60Hz, 450W and 8A.
Propane or LP
If your Breakfast Club is factory built for LP, the regulator supplied is set to 11” water column and is for use
with LP gas only. The factory supplied regulator and hose must be used with a 20 lb LP cylinder. Do not use
any replacement regulator other than that specified be Twin Eagles.
Natural Gas or NG
If the Breakfast Club is factory built for natural gas, the regulator supplied is set for 4” water column. No
not use any replacement regulator other than that specified by Twin Eagles.
Shipment
This Breakfast Club is inspected before leaving the factory. The shipping carrier assumes full responsibility
for the safe delivery of the appliance. Check for possible shipping damage immediately after unpacking. If
the Breakfast Club is found to be damaged, save the packaging material and contact the shipping carrier
immediately.
Unpacking
Remove all packaging materials, labels and protective plastic film. DO NOT LEAVE UNIT UNDER THE
SUN WITH PROTECTIVE FILM ON FOR AN EXTENDED PERIOD OF TIME AS IT WILL BE
DIFFICULT TO REMOVE THE FILM.
