Quick ROBOtics light weight tORch
4-8
SM-QRLTORCH
INSTALLATION AND DISASSEMBLY
16. Trim the conduit extending from the front of the conductor
tube assembly by following the steps below:
Method “A” – Using a tape measure or scale, mark
and cut the conduit to the cut length (1 5/16").
Refer to Figure 6 — Method “A”.
Method “B” – The diffusers have a machined
groove around the outer diameter. Position the
diffuser as shown in Figure 6 — Method “B” and
mark and cut the conduit.
•
•
1 5/16”
METHOD “A”
METHOD “B”
17. After trimming to length, remove any obstructions
from the end of the conduit radius.
18. Re-install the diffuser, tip and nozzle onto the
conductor tube assembly.
19. Loosen the fixture connection and insert the torch and
conductor tube assembly into position. The key located
on the torch body should be placed into the mating
keyway on the fixture until it bottoms out against the
fixture plate. Tighten the connection to secure the
assembly in place.
Figure 7: Locating Key
3.02 Disassembly
To disassemble the torch and cable assembly from the fixture,
reverse the steps noted in Section 3.01.
KEY
CUT LINE
20. Install the rear connector plug into the feeder.
21. Connect the rear control cable and front e-stop jumper
cable assemblies, if applicable.
22. The torch is now ready to place into operation.
Figure 6: Conduit Cut Length
