Quick ROBOtics light weight tORch
1-1
SM-QRLTORCH
SAFETY INSTRUCTIONS AND WARNINGS
5. All ground connections must be checked periodically
to determine that they are mechanically strong and
electrically adequate for the required current.
6. When engaged in alternating current, welding, or cutting
under wet conditions or warm surroundings where
perspiration is a factor, the use of reliable automatic
controls for reducing the no-load voltage is recommended
to reduce shock hazard.
7. When the welding or cutting process requires values of
open circuit voltages in alternating current machines
higher than 80 volts, and direct current machines higher
than 100 volts, means must be provided to prevent the
operator from making accidental contact with the high
voltage by adequate insulation or other means.
8. When welding is to be suspended for any substantial
length of time, such as during lunch or overnight, all
electrodes should be removed from the electrode
holder and the electrode holder carefully located so that
accidental contact cannot occur.
9. The holder must be disconnected from the power source
when not in use.
10. Never immerse Mig-Guns, electrode holders, tig torches,
plasma torches, or electrodes in water.
WARNING
SMOKE, FUMES AND GASES CAN BE DANGEROUS
TO YOUR HEALTH.
1.01 Welding Hazards
WARNING
ELECTRIC SHOCK CAN CAUSE INJURY OR
DEATH.
INSTALL AND MAINTAIN EQUIPMENT IN ACCORDANCE
WITH THE NATIONAL ELECTRICAL CODE (NFPA 70)
AND LOCAL CODES. DO NOT SERVICE OR REPAIR
EQUIPMENT WITH POWER ON. DO NOT OPERATE
EQUIPMENT WITH PROTECTIVE INSULATORS
OR COVERS REMOVED. SERVICE OR REPAIR TO
EQUIPMENT MUST BE DONE BY A QUALIFIED REPAIR
TECHNICIAN, OR TRAINED PERSONNEL ONLY.
1. Do not touch live electrical parts.
2. Do not touch an electrode with bare skin and electrical
ground at the same time.
3. Always keep welding gloves dry and in good condition.
NOTE
Aluminized protective clothing can become part
of the electrical path.
4. Keep oxygen cylinders, chains, wire ropes, cranes, hoists,
and elevators away from any part of the electrical path.
SECTION 1:
SAFETY INSTRUCTIONS AND WARNINGS
!
!
WARNING
SERIOUS INJURY OR DEATH may result if welding and cutting equipment is not properly installed, used and maintained.
Misuse of this equipment and other unsafe practices can be hazardous. The operator, supervisor and helper must
read and understand the following safety warnings and instructions before installing or using any welding or cutting
equipment.
The welding and cutting process is used in many potentially dangerous environments such as elevated heights, areas
of limited ventilation, close quarters, around water, in hostile environments, etc., and it is important that the operator(s)
are aware of the dangers associated with working in these types of conditions. Be certain that the operator(s) are
trained in safe practices for environments in which they are expected to work and under competent supervision.
It is essential that the operator, supervisor and all other personnel in the work area are aware of the dangers of the
welding or cutting process. Training and proper supervision are important for a safe work place. Keep these instructions
for future use. Additional recommended safety and operating information is referenced in each section.
