twall Premium64, Руководство пользователя

Страница: 21 / 40

t wall
®
Premium64 standard Color mobile / stationary User manual | Rev. 1.0.3
E| 21
III. Attaching the angles for wall
fastening:
Step
10
In order to attach the angles
A2f
to the side supports
(fig. 3.2-12)
, please
take the following measurements:
Step
11
Insert eight (8) T-nuts
M8
into
the upper lead channels at the inside of the
side supports and align them according to
the measurements taken (4 T-nuts per side of
which 2 are per measurement).
Step
12
Now mount the angles
A2f
to
the upper lead channels at the inside of the
side supports using two (2) Verbus-Rippscrews
M8x20
per angles
(fig. 3.2-12)
. Please
tighten the screws appropriately (ca. 25 Nm).
IV. Setting up the aluminium frame:
Step
13
To be able to assemble the
aluminium frame you have to prepare drill
holes in the wall the device will be installed to.
You will require a hammer drill, a drill bit (size
12 mm | 0.47 inch
) and protective work
equipment:
Distances on the wall
t
wall
® Premium64 stationary
From the floor to the middle of the lower drill hole: 660 mm | 25.98 inch
From the middle of the lower drill hole to the middle of
the upper drill hole: 1365 mm | 53.74 inch
The horizontal distance from hole middle to hole middle: 1883 mm | 74.13 inch
Step
14
Place the provided plastic dowels
10x70 in the drill holes at the wall.
PLEASE NOTE: Basically, the height of the angles can vary especially if there any obstacles in the wall the
device will be assembled to such as trusses or pipelines.
PLEASE NOTE: Plasterboard walls have to be covered at least twice. The safe fastening of the device should
be checked on a regular basis.

fig. 3.2-12
angle for
mounting
on the t wall
®

Distances:
t
wall
® Premium64 stationary
From the floor to the lower edge of the lower angles
(close to the shield): 635 mm | 25 inch
From the lower edge of the lower angles to the upper
edge of the upper angle (close to the cover caps):
1415 mm | 55.71 inch