twall Premium64, Руководство пользователя

Страница: 20 / 40

t
wall ® Premium64 standard Color mobile / stationary User manual | Rev. 1.0.3
20 |E
Step
7
Insert two (2) T-nuts into the
just assembled short frame profile again, this
time 1 x at the top left and 1 x at the top
right. Afterwards shove the long frame profile
A2c
with the pre-assembled PVC installation
channel into the lower lead channel between
the side supports, move it until it seats on the
short frame profile.
The PVC installation channel should point
upwards (towards you). Now insert two (2)
T-nuts into the leading channel of the long
frame profile and align them as follows:
From each side measure a distance of
930
mm | 36.61 inch
from the inner edge of the
side supports to the middle of the screws the
profile angles will be screwed on with. Attach
two (2) profile angles
A2e
to the long and the
short frame profiles again
(fig. 3.2-9)
. After-
wards tighten the profile connectors of the
long frame profile
A2c
with a corresponding
Allen key (ca. 25Nm).
Please pay attention to a horizontal alignment
of the frame profile so that a correct
placement of the basic modules is ensured
(spirit level).
Step
8
Please go back to step
6
and
step
7
and repeat the procedure with the
remaining frame profiles
A2c
and
A2d
.
Please make sure that the ends of the last
frame profile
A2c
and the side supports
A2a
are on the same level and will be flush-
mounted
(fig. 3.2-10)
. Also, please check
again if you have strongly tightened all the
profile connectors (ca. 25Nm).
Step
9
Finally, put the two (2) black
cover caps on the top ends of the side
supports
A2a (fig. 3.2-11)
and press the
four (4) grey PVC combination profiles
into the outward lead channels of the side
supports (above the cross pieces of the profile
connectors, 2 x at the right side and 2 x at the
left side).
fig. 3.2-11
fig. 3.2-9
fig. 3.2-10