twall Premium64, Руководство пользователя

Страница: 11 / 40

t wall
®
Premium64 standard Color mobile / stationary User manual | Rev. 1.0.3
E| 11
Step

Put the frame base in an upright
position in order to attach the four (4) rubber
feet to the bottom of the frame base.
(fig. 3.1-7 and 3.1-8)
The projecting profiles
should point upwards. Push the rubber feet
into the lower lead channels and position the
adhesive feet at the outer lower edges
of the frame base profiles
A1c
.
II. Attaching the profile angles to the
frame base:
Step

The four (4) profile angles
A1e
will be fitted to the inner sides of the frame
base profiles
A1c
and
A1d (fig. 3.1-9)
. Place
the twelve (12) T-nuts
M8
in the lower lead
channels of the frame base profiles A1c and
A1d (3 T-nuts per side and angle respectively).
Insert the T-nuts by half-twisting them into the
lead channels with the swivel ball ahead
(fig. 3.1-10 and 3.1-11)
.
Roughly estimate the concentric position of the
profile angles and align the T-nuts appropriately.
Since the weights will be placed on the profile
angles, the angle should be attached with the
surface pointing towards you. Screw on the
profile angles using the T-nuts and the twelve
(12) fillister head screws
M8x16
with flange
(3 per angle).
III. Fastening the joints to the angles
braces:
Step

At first, the four (4) threaded
inserts will be screwed into the open ends of the
angles braces (
A1g
) using a
9 mm | 0.35 inch
slot screwdriver. In order to attach the joints
A1f
to the angles braces, put two (2) adjusting
blocks opposite of each other into the provided
holes. It is very important to insert the adjusting
blocks into the holes at the sides where the arms
of the joints are located and that the number 8
on top of the adjusting blocks points outwards.
(fig. 3.1-12 and fig. 3.1-13)
. You will find that
the adjusting blocks marked with number 8 will
fit exactly into the lead channels. Now position
the joints at the ends of the angles braces and
bolt them together using the four (4) socket
head screws
M8x25
, the washers and the
corresponding Allen key.
(fig. 3.1-14)
.
Please take care to mount all joints to the angles
braces facing the same direction. To simplify the
process, we would recommend attaching the
angles braces to the frame base once having
assembled the aluminium frame.
fig. 3.1-8 fig. 3.1-7
fig. 3.1-12 fig. 3.1-13
fig. 3.1-14
arms of the joint
fig. 3.1-9
profile
angles
fig. 3.1-11 fig. 3.1-11
fig. 3.1-10
swivel ball