TWAC Protectant, Руководство по установке

Страница: 47 / 182

P a g e | 45
TWAC Installation Manual Ver: 0118 CodeMark™ CMA-CM40036
SLAB REPAIRS
These are usually required due to the incorrect positioning of a pipe prior to the slab pour
or a slab break out caused by a frame anchoring bolt or nail. Check for these prior to
installing the perimeter barrier.
The slab repairs are preferred to be fixed to the vertical edge before filling with concrete.
If the repair is in an area to be water proofed, DO NOT apply the repair to the top of the
slab as this may result in a repair claim at a later time.
You must ensure the area to be repaired is free of debris prior to applying
ADULETH Termiticide or sufficient bonding may not occur.
In areas difficult to access, it may be advisable to apply a liberal coat of
ADSOL ADHESIVE to either flush out loose particles or bond them to the slab prior to
applying the ADULETH Termiticide.
When certain the area to be repaired is sufficiently clean, ADULETH Termiticide can be
applied to the surface of the slab prior to installing the termite barrier. Be careful to press
the barrier firmly into the adhesive to ensure there are no voids. ADSOL may also be
used.
Protectant
™ Termite Barrier can be installed on top of the slab in cases where it will not
interfere with floor coverings e.g. vinyl.