36
Network Camera User Manual
1. Enable line crossing detection and select the snapshot type and the detection target.
Save Panoramic Picture to SD Card
: If it is enabled, the detected panoramic pictures will
be captured and saved to the SD card when the targets cross the alarm line.
Save Target Cutout to SD Card
: If it is enabled, the detected target cutout pictures will be
captured and saved to the SD card when the targets cross the alarm line.
Note
: To save snapshots to the local PC, please enable “Local Smart Snapshot Storage” in the
local config interface first. To save snapshots to the SD card, please install an SD card first.
Detection Target
:
Human:
Select it and then alarms will be triggered if someone crosses the pre-defined alarm
lines.
Motor Vehicle
: Select it and then alarms will be triggered if a vehicle with four or more
wheels (eg. a car, bus or truck) crosses the pre-defined alarm lines.
Non-motor Vehicle
: Select it and then alarms will be triggered if a vehicle with two wheels
(eg. a motorcycle or bicycle) crosses the pre-defined alarm lines.
All of the three types of objects can be selected simultaneously. Please select the detection
objects as needed. If no object/target is selected, alarms will not be triggered even if line
crossing detection is enabled.
2. Set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as fire detection. Please refer to
4. Click “Save” button to save the settings.
5. Set area and sensitivity of the line crossing alarm. Click the “Area and Sensitivity” tab to
go to the interface as shown below.
