Tuttnauer 2840 ELV-D, Руководство по эксплуатации и обслуживанию

Страница: 77 / 91

Page 76
10.4 Loading
•
Load the autoclave properly according to instructions in sec. 9.
PREPARATION BEFORE STERILIZATION.
•
Select the program.
▪
UP key: next program.
▪
DOWN key: previous program.
•
Verify that you chose the required program.
10.5 Closing the door
1. Hold the opening handle in open position, while pushing the door until
it comes to closed position, then release the handle.
2. The open door symbol is replaced by the message "System
Ready".
10.6 Starting cycle
If your autoclave is WR configuration, for the first cycle, fill the mineral
-free water reservoir. If "Supplied Distilled Water Error" message
appears between the cycles, add water to the reservoir until the
message disappears. Do not fill the reservoir completely!
•
Start the cycle by pressing the START/STOP key.
10.7 Unloading
When the cycle ended successfully (including pressing the
START/STOP key, or any failure, after completing the sterilization
stage) message "Cycle Ended" (and the relevant failure message, if
applicable) is displayed on the screen.
•
Verify that there is no pressure in the chamber, according to the
reading on the display. Only then you may open the door.
•
Open the autoclave. (see sec. 10.2 Opening the door)
Warning
To avoid severe injuries from hot steam when opening the door:
⎯
It is strictly forbidden to lean on the autoclave.
⎯
It is strictly forbidden to place your hand or any part of your
body over the door.