Page 5
Step 26:
Lay fiberglass rod into groove and
press down so it’s flush with surface.
Step 25:
Apply white Gorilla Glue or Quick
Grip into slot as shown.
Step 24:
(continuation) Slice from front to
rear as shown.
Step 23:
Make a slice roughly 1/8” deep with
sharp knife along line marks as shown.
Step 21:
Gather parts and tools.
Assemble Fuselage
You’ll need : Foam fuselage pieces, ruler,
white gorilla glue or quick grip glue,
scrap EPP / 40 grit sanding block,
sharp knife, 1/16” fiberglass rods, ruler
dremel tool /cutoff wheel, 2 large blocks
Step 22:
Cut the fiberglass rods to produce
four (4) 48” and eight (8) 24” pieces
Work glue into
the entire slot
from nose to tail.
Cut the 48” pieces
first!
You’ll use the 24”
pieces now. Save
the other ones for
the wing later
There are 8 line
marks for you to
slice
Use your finger as
a depth guide
Step 29:
Mark fuselage 5-3/4” from edge as
shown (both sides)
Step 27:
Work rod into slot. Rod will stay in
place once glue starts to set.
Repeat for
both sides (all
8 lines)
Insure fuselage
is straight
while glue
cures.
Step 28:
Gather parts and tools.
Join Wings to Fuselage
You’ll need : Assembled Foam fuselage and wings,
white gorilla glue or quick grip glue,
hobby knife, (2) 1/16” fiberglass rods,
tall blocks/supports, weights, ruler,
plastic wrap, medium CA, kicker
old credit card
Step 30:
Mark center of fuselage as shown
across previous mark.
This will be the
wing front LE
location
