Page 21
Step 181:
Make a small bend in 1/16” wire
as shown.
Step 182:
Make next bend to trap tailwheel
and continue bending as template shows.
Step 183:
Make final bends and trim wire
according to template.
Refer to template
pages for tailwheel
bending guide.
Step 188:
Use center hole to orient the “H”
mount and mark rod locations on “H” mount
Step 187:
Insert “H” mount as shown with
longest legs down
Step 185:
Apply Quick grip or white Gorilla
Glue and G10 supports and clamp till dry.
Step 184:
Slice the rudder as shown to
receive wire.
Slice should be next
to hinge for best
strength.
Refer to template for
G10 reinforcement
location
Step 186:
Gather parts and tools.
Final Assembly
You’ll need :
pen, hobby knife, Dremel tool, ruler,
“H” motor mount, rubber bands/O rings,
battery, velcro strap, 4-40 nylon bolts
Scrap wood, G10 or plastic
(ie credit card thickness,
zip ties, scrap 1/16” rod, motor, ESC
Motor thrust line
should be about 1/4”
above wing /fuse
center
See template
drawing side view
Step 189:
Insert round grinder into Dremel
tool.
Step 190:
Make “half round” slots as shown
between your marks for rods to seat.
