Tuchel PLUS 560, Руководство по эксплуатации

Страница: 44 / 102

Coupling and uncoupling the sweeper
4.3.8 Readjustment of sweeping profile
4-38
•
The safety regulations from chapter 4.2 apply.
During operation of the Sweeper PLUS 560
there should be a swept profile of a = 6 - 10
cm (i.e. when raising the sweeper the width
of the cleaned surface should be 6 - 10 cm).
➔
Check swept width on
level ground!
If no sufficient width is still available, or if
the ground contact pressure is too low,
then the main brush must be adjusted
evenly on both sides by using the
adjusting-lever system.
➔
Take account of the actual
weight of the main brush
itself.
1
2
a
Fig. 4.27
➔
Ensure twist and kink-free
run of the hydraulic
hose lines.
•
Raise sweeper but keep close
to ground.
•
Pull the locking lever (1) of the
adjustment grid - to the rear.
•
Set the locking lever to the desired
position on the adjustment grid (2).
•
Carry out the adjustment of the
main brush equally on both sides.