35
Status output
15.3
●
Setting of condition for status output
Setting procedure of condition for status output
①
Press
ON/OFF
key and
▲
key at a time for 3 seconds or more.
DENGER
,
AC
,
DC
lamps blink and the test time display is lit up with “
”.
The highest digit of the voltage display blinks.
②
The item to set can be moved with
or
key.
③
Refer to the following table for the items to select.
TEST VOLTAGE
CURRENT
kV
“
” or “ ” blinks at selection of each item.
: To select
: Not to select
key:
Move to right, but when pressed at the item
POWER ON, moves to the TEST/H.V. OUT.
key:
Move to left, but when pressed at the item
TEST/H.V. OUT, moves to POWER ON.
Selection item
of status output
Lamps to synchronously blinks
at the setting
TEST/H.V. OUT
DANGER
,
AC
,
DC
lamp
TEST
AC
DC
GOOD
GOOD
NG
HIGH
LOW
READY
READY
lamp
REMOTE
REMOTE
lamp
POWER ON
－－－－
Finish of setting
Press
ENTER
key, then the setting is memorized and returns to
READY
status.
When the
EXIT
key (
SHIFT
and
ENTER
key at a time) is pressed, the setting mode
of the status output condition is interrupted and the tester becomes
READY
status.
The setting mode of the status output condition at that time is the condition before
entering the setting mode of the status output condition.
When the
EXIT
key (
SHIFT
and
ENTER
key at a time) is pressed while “
” is
lit up, the setting mode of the status output condition is interrupted and the tester becomes
READY
status.
The setting mode of the status output condition at that time is the condition before
entering the setting mode of the status output condition.
ON/OFF
ENTER
WRITE
READ
LOCK
EXIT
SHIFT
BUZZER
PROTECT
○
ONLINE
○
○
○
○
○
KEY LOCK
DISCHARGE
REMOTE
READY
AC
DC
No.
s
mA
HIGH SET
SET
LOW
HIGH
GOOD
LOW
MODE
JUDGE
CURRENT
TEST VOLTAGE
MEMORY
RANGE
TIME
kV
kV
AC
DC
◎
◎
