TSMC Solar TS-110C1, Инструкция по установке и безопасности

Страница: 16 / 18

Bolt Method
The module can be mounted by bolting the frame to mounting structure. This method requires 4 sets of: M6 bolt,
M6 spring washer, M6 flat washer and M6 nut per module. There are eight mounting holes on the back side of
module, however only
the 4 mounting hole locations denoted “M1” in Figure 6 can be used. These 4 holes are
offset from the short edge of module by 407.5m
m [16.04”].
The installation method (Figure 15) requires that the spring washer be first placed on the bolt, followed by the
insertion of the bolt first through the module mounting hole in the aluminum frame then through the system rail.
Finally, after putting the flat washer and nut on the bolt, use torque of 6.1 N-m to screw the nut tight to complete
the installation. The bolt mounting method cross section is as shown in Figure 16.
SEE DETAIL A
DETAIL A
M6 BOLT
M6 SPRING WASHER
M6 FLAT WASHER
M6 NUT
Figure 15 Module Bolt Mounting Method
M6 BOLT
M6 SPRING WASHER
M6 FLAT WASHER
M6 NUT
Top edge of system rail
Figure 16 Bolt Mounting Method - Cross Section