TSE DPT40-B, Руководство пользователя

Страница: 206 / 472

Storage
RK80614,0000060 -19-04FEB15-1/1
ZE59858,00002D8 -19-04FEB15-1/1
Engine Storage Guidelines
IMPORTANT: Special considerations should be
taken prior to storage when using BioDiesel.
See BioDiesel Fuel in the Fuels, Lubricants,
and Coolant Section.
1. John Deere engines can be stored outside for up to
three months with no long-term preparation if covered
by a waterproof covering. No outside storage is
recommended without a waterproof covering.
2. John Deere engines can be stored in a standard
overseas shipping container for up to three months
with no long-term preparation.
3. John Deere engines can be stored inside for up to six
months with no long-term preparation.
4. John Deere engines expected to be stored more than
six months must have long-term storage preparation.
See Preparing Engine for Long-Term Storage in the
Storage Section.
Preparing Engine for Long-Term Storage
IMPORTANT: Any time the engine is not used for over
six months, the following recommendations for
storing it and removing it from storage helps
to minimize corrosion and deterioration.
IMPORTANT: Long-term storage is not advised when
using BioDiesel. For storage longer than one
year, use straight hydrocarbon fuel.
If BioDiesel must be used it is recommended
the blend not exceed B7 and a high-quality
fuel stabilizer be used. Storage should
not exceed one year.
For more information see BioDiesel Fuel in the
Fuels, Lubricants, and Coolants Section.
NOTE: The following storage preparations are used for
long-term engine storage up to one year. After
that, the engine should be started, warmed up, and
retreated for an extended storage period.
1. Change engine oil and replace filter. Used oil does not
give adequate protection. Add 30 mL of rust preventive
oil to the engine crankcase for every 1 L of engine oil, or
1 oz of rust preventative oil per 1 qt. of engine oil. This
rust preventive oil should be an SAE 10 oil with 1%-4%
morpholine or equivalent vapor corrosion inhibitor.
2. Replace air cleaner.
3. Draining and flushing of cooling system is not
necessary if the engine is only stored for less than one
year. However, for extended storage periods of a year
or longer, it is recommended that the cooling system
be drained, flushed, and refilled. Refill with appropriate
coolant. See Diesel Engine Coolant (engine with wet
sleeve cylinder liners) in the Fuels, Lubricants, and
Coolants Section.
4. Prepare a solution of diesel fuel and rust preventive oil
in a temporary container, add 78 mL of rust preventive
oil per 1 L of diesel fuel, 10 oz. of rust preventive oil
per 1 gal. of diesel fuel.
5. Remove existing lines and plugs as required. Run a
temporary line from the temporary container to the
engine fuel intake before the fuel filters, and another
temporary line from the fuel return to the temporary
container, so rust preventive oil solution is circulated
through the injection system during cranking.
IMPORTANT: Do not operate starter more than 30
seconds at a time. Wait at least 2 minutes for
starter to cool before trying again.
6. Crank the engine several revolutions with starter.
Do not allow the engine to start. This allows rust
preventive oil solution to circulate.
See your authorized dealer for the proper procedure
for your application.
7. Remove temporary lines installed in Step 5 above,
and replace any lines or plugs previously removed.
8. Loosen (or remove) and store fan and alternator
poly-vee belt.
9. Remove and clean batteries. Store them in a cool, dry
place and keep them fully charged.
10. Disengage the clutch for any driveline.
11. Clean the exterior of the engine with salt-free water
and touch up any scratched or chipped painted
surfaces with a good quality paint.
12. Coat all exposed bare metal surfaces with grease or
corrosion inhibitor if not feasible to paint.
13. Seal all openings on engine with plastic bags and tape.
14. Store the engine in a dry protected place. If engine
must be stored outside, cover it with a waterproof
canvas or other suitable protective material and use
a strong waterproof tape.
70-1 032715
PN=159