TruVision TVB-5412, Руководство по настройке

Страница: 60 / 90

58 TruVision ANPR IP Camera Configuration Manual
9. Specify the linkage method when an event occurs. Select one or more response
methods for the system when a motion detection alarm is triggered:
Normal Actions This is a group selection. It automatically selects “Send Email”,
“Notify Alarm Recipient” and “Upload to FTP/Memory Card/NAS”.
Send Email Send an email to a specified address when there is a motion
detection alarm.
Note: You must configure email settings before enabling this
option. See “Email parameters” on page 36 for further information.
If you want to send the event snapshot together with the email,
select the
Attached Snapshot option.
Notify Alarm Recipient Send an exception or alarm signal to remote management
software when an event occurs.
Upload to FTP/Memory
Card/NAS Capture the image when an alarm is triggered and upload the
picture to NAS, Memory Card or FTP server.
Note : To upload the snapshot to NAS, you must first configure the
NAS settings. See “NAS settings” on page 70 for further
information.
To upload the snapshot to an FTP, you must first configure the
FTP settings. See “FTP parameters” on page 36 for further
information. Enable the
Upload Type option.
To upload the snapshot to FTP and NAS when motion detection
or an alarm input is triggered, you must also select
Enable Event-
triggered Snapshot under the snapshot parameters. See
“Snapshots” on page 67 for further information.
Trigger Alarm Output Trigger external alarm outputs when an event occurs.
Note: This option is only supported by cameras that support alarm
output.
A->1 Trigger the alarm input A->1.
Trigger Recording Trigger the camera to start recording.
A1
10. Click Save to save changes.
To set up motion detection in advanced mode:
1. Click Configuration > Camera Configuration > Alarm/Event > Motion
Detection .
2. Select the Enable Motion Detection check box. Select the Enable Dynamic
Analysis for Motion check box if you want to see real-time motion events.
Note : If you do not want the detected object to be marked with the green frame,
select Disable from Configuration > Local Configuration > Live View Parameters >
Enable Meta Data Overlay.