Truma Mover XT L, Руководство по эксплуатации

Страница: 20 / 84

20 EN
Minimum installation dimensions
As shown in the illustration, the equipment can only be
installed on frames with a 5° incline (lightweight con-
struction chassis) and behind the axle.
min. 160 mm
20 mm ca. 5° ± 1
Driving direction
Figure 6
Installation is only possible on caravans with the following
dimensions.
ca. 1400
Caravan floor
Figure 7
All dimensions in mm.
The Mover XT L must not be fitted to caravans
with other frames.
You must not drill into or weld onto the vehicle frame.
Wheel suspension parts must not be removed under any
circumstances.
Selecting a location
The Mover XT L is installed behind the axle.
Installation in front of the axle is not possible because of a
lack of ground clearance. Any mud guards that are present
must be removed. Only the provided screws / bolts must be
used to attach the Mover XT L.
Mud guards
When a Mover XT L is fitted, the existing mud guards must be
moved / adapted if necessary (max. distance between tyre /
mud guard 300 mm).
If the original mud guards cannot be used, the Truma mud
guard set (part no. 60031-08200) must be used and adapted.
The mud guards are installed behind the axle. No mud
guards are required in front of the axle.
max. 200 mm
Driving direction
Mover
max.
300 mm
Mover XT L
Figure 8
Adapting the mud guards to the Mover
1. Remove the mud guards.
2. Fit Mover XT L in accordance with the following installation
instructions.
3. Determine dimensions a and b and transfer to mud guards.
The top leg of the fastening bracket must face towards the
rear of the caravan.
Determining the cut-out sizes
a
b
a
b
Mover XT L
Figure 9
Cut out the template at the end of the installation instructions,
place onto mud guard, transfer contour and cut out (figure 6).
Pay attention to left and right sides!
If necessary, make recesses in the mud guard for the apron
contour. Secure the mud guard 300 mm from the tyre on the
underside of the caravan.
Fitting the drive elements
The frame of the vehicle must be free of rust, grease and
heavy soiling. There must be no damage in the area of the
wheel suspension.
The wheels and tyres fitted on the caravan must be of the
same size and type, and must be inflated in accordance with
manufacturer’s instructions.
Remove all components from packing and place on the floor.
Figure 10